Introduction简介:
著名结构设计专家Clive Maier著。[20070629更新为2006年10月新版本]
This set of hints and tips for plastics product designers is intended as a source book and an 'aide
mémoire' for good design ideas and practices. It is a source book for plastics product designers at all
levels but it is primarily aimed at:
• student designers carrying out design work for all levels of academic studies;
• non-plastics specialists involved in the design of plastics products;
• plastics specialists who need to explain their design decisions and the design limitations to nonplastics
specialists.
The book covers each topic in a single page to provide a basic reference to each topic. This space
constraint means that each topic is only covered to a basic level. Detailed plastic product design will
always require detailed knowledge of the application, the processing method and the selected plastic.
This information can only be provided by raw materials suppliers, specialist plastics product designers
and plastics processors but there is a need to get the basics of the product design right in the first
instance.
Using the hints and tips provided in this guide will enable designers to reduce initial errors and will lead
to better and more economic design with plastics.
I hope this short work will improve the basic design of plastics products and if it can do this then it will
have served it’s objectives.

Cover封面:
coming soon....

Table of Content目录:
Preface ........................................................................................... 1
Introduction .................................................................................... 2
Injection moulding ......................................................................... 4
Basics
1. Wall thickness .......................................................................................... 5
2. Corners ...................................................................................................... 6
3. Ribs .......................................................................................................... 7
4. Bosses .................................................................................................... 10
5. Design for recycling .................................................................... Planned
Special features
6. Living hinge ........................................................................................... 13
7. Bearings ................................................................................................. 15
8. Gears ....................................................................................................... 18
Assembly
9. Press fits ................................................................................................. 23
10. Snap-fits ................................................................................................. 24
11. Hot air staking ........................................................................................ 28
12. Ultrasonic welding .................................................................................. 30
13. Hot plate welding .................................................................................... 35
14. Spin welding ........................................................................................... 36
15. Friction welding ...................................................................................... 37
16. Induction welding ................................................................................... 38
17. Laser welding .......................................................................................... 39
18. Adhesive and solvent bonding .............................................................. 40
Special techniques
19. Design for outsert moulding ....................................................... 45
20. Design for gas assist injection moulding .................................. Planned
Extrusion ..........................................................................................
21. Design for profile extrusion ........................................................ Planned
Blow moulding .................................................................................
22. Design for extrusion blow moulding .......................................... Planned
Thermoforming ................................................................................
23. Design for thermoforming ........................................................... Planned

Notic警告:
Not for commercial use of any kind!

Download下载: 本站资源下载必读
[HTTP]goeway.cn_Design_Guides_for_Plastics.9660BCABF1ED1CD47C5.pdf
  [FTP]goeway.cn_Design_Guides_for_Plastics.9660BCABF1ED1CD47C5.pdf [使用单线程，否则无法下载]

FTP请注意开机时间,如无法下载请换个时间再试!
请使用单线程下载FTP资源,否则会被禁止登陆60分钟!
推荐使用Leapftp.rar下载本站FTP资源.